WARNING: Hazardous Voltage. Contact may cause electric shock, burn, or death. Disconnect all power from the unit prior to attempting any servicing of the equipment. Service should only be performed by qualified personnel.
CAUTION: Use proper ESD precautions when working on equipment to prevent damage to the internal components.
Applies to:
Instant Replay3, model DR-1000
Symptom:
Failed LCD.
Possible Reason(s):
Various
Solution(s):
Please see the instruction in the following link.
CS048-IR3-Display-Replacement-Instructions
Basic instructions:
4.1. WARNING: Remove power from the unit (disconnect the power supply) prior to servicing the
unit.
4.2. WARNING: Use standard ESD precautions to prevent damage to the display or system.
4.3. Remove the two screws from the rear of the display housing using a #1 Philips screwdriver.
4.4. Remove the front display bezel and tilt the display forward.
4.5. Lift the clamping lever on the main data cable (white cable) on the back of the daughterboard to
release.
4.6. If the new display came with a daughterboard already attached, please skip to step 4.11
4.7. Lift the two clamping levers on the daughterboard to release the two LCD cables.
4.8. Remove the daughterboard from the old display. CAUTION: Do not pry off. The adhesive will release with
gentle pulling on the daughterboard.
4.9. Attach the daughterboard to the two cables on the new display but do not attach the
daughterboard to the LCD screen.
4.10.
Attach the white, main data cable to the daughterboard and rest the daughterboard in the
slot in the rear of the display housing.
4.11. Set the display into the rear housing. (Note: If your display has the daughterboard
attached, only attach the white main data cable and then set the display in place.)
4.12.
Install the front display bezel making sure the two posts at the bottom are firmly in the
slots in the bottom of the rear housing.
4.13. Reinstall the two screws in the rear of the housing. CAUTION: Do not over tighten.